| Maintenance of pill making machine |
|
| 2022-8-28 publish |
Chinese medicine pill making machine can produce honey pill, concentrated pill, water pill, water pill, pill food, can also be coated and drying. To make the pill uniform and beautiful. Especially suitable for small pharmaceutical factory, large and medium-sized pharmaceutical factory trial production room, traditional Chinese medicine research institute, hospital, private clinic, Chinese medicine store, rare tonic site processing and sales point, the whole machine is made of stainless steel, in line with GMP standards. However, in reality, we should also do a good job of cleaning in time after using the pellet making machine, which can not only prolong the service life of the pellet making machine, but also ensure that the next time the pellet making is more clean and hygienic.
Please clean inside and air dry after use of pill making machine.
1, Chinese medicine pill making machine when the use of the most appropriate ambient temperature is -5℃ to 40℃, relative humidity is less than 90%. No conductive dust and corrosive metal gas around, placed in a ventilated, clean position.
2. During operation, there should be no other irrelevant items on the workbench. The shot making machine is placed on the flat table. In the case of confirming the power supply voltage, the power supply should be close to the table. The power socket should have a reliable grounding wire.
3. After use, remove the inner hexagonal screw, open the upper and lower parts with the roller as the boundary, remove the four rollers, and clean them with medical alcohol. or according to the need to replace the different specifications of the roller, can be installed according to the picture reset.
4. When scrubbing with alcohol, replacing the ball roller and the clutch roller, the total power supply must be cut off and the power plug pulled out to avoid personal accidents.
5, in the boot use, it is strictly prohibited to use hand and brush or other tools to contact the ball roller and the clutch roller, in order to avoid pricking fingers, it is strictly prohibited in the supreme cover shell, gear box cover protection, power processing shot, to avoid unnecessary personal accidents.
6. In case of power cable damage (such as bare wire exposed, etc.), the power cable must be used. Purchase replacement at local office maintenance department. If the switch or socket fails, it must be stopped. It is forbidden to change the line to continue to use. The beginning or socket of the same specification should be replaced in time to avoid mechanical and personal accidents.
7, do not do cleaning and maintenance after use will make its performance decline, affect all aspects, so after use simply do a maintenance, you can avoid the incidence of failure.
|
|
|
0938-2721678 
