| What are the maintenance methods for the traditional Chinese medicine pill-making machine? |
|
| 2026-4-25 publish |
Herbal medicine pill-making machine Complete maintenance methods (Simple and easy to remember, practical version)
1. Daily maintenance (Must do)
Timely and thorough cleaning
Stop the machine, disconnect the power supply, remove the strip mouth, rolling wheel, hopper, and feeding screw;
Use clean water and soft brushes to clean the residual powder, paste, and honey residue;
Do not use high-pressure water guns to directly spray the circuit board of the machine to avoid water ingress and short circuit.
Anti-sticking and anti-mold
The honey pills and water honey pills have high viscosity, and must be cleaned up on the same day;
Wipe and dry all components in contact with medicinal materials to prevent mold and bacterial growth of the drug residue.
Check wear parts
Check if the rolling wheel, blades, and brushes are worn, stuck, or have accumulated dirt;
Check the tension and sound of the belts and chains, and check for any abnormal noise.
2. Weekly regular maintenance
Lubrication maintenance (Key point)
For moving parts such as bearings, gears, transmission chains, and rotating shafts, add food-grade lubricating oil / grease;
⚠️ Note: Do not apply ordinary engine oil to the parts in contact with medicinal materials to prevent contamination of the medicine.
Deep cleaning
Use neutral cleaner to wipe the body and stubborn drug stains in the mold gaps;
After drying, assemble and keep the entire machine dry.
Circuit and machine inspection
Check if the power cord, switch, and motor are overheating or aging;
Clean the dust on the machine box for heat dissipation, and ensure good heat dissipation.
3. Monthly / Long-term maintenance
Whole machine disassembly and repair
Disassemble all components in contact with medicinal materials for deep cleaning and disinfection;
Check the wear of the screw, out-strip cylinder, etc., replace them in time if severely worn to prevent uneven out-strip and inconsistent pill size.
Tightening and calibration
Tighten all screws and fasteners;
Adjust the gap of the rolling wheel and the cutting speed to ensure uniform pill particles. Anti-rust and anti-corrosion
Non-stainless metal moving parts should be lightly coated with protective grease;
When not in use for a long time, clean and dry them, then put on a dust cover and place them in a dry and ventilated area to prevent moisture and rust.
IV. Special Precautions (To Extend Machine Lifespan) Before use
First, idle and rotate for 1-2 minutes to check if the operation is smooth and if there are any abnormal sounds;
After the mold and components are installed properly, start feeding the material.
During use:
Do not forcibly feed the material or add excessive amounts to prevent the motor from overloading and the screw from getting stuck;
If the material is too hard or too dry, it needs to be kneaded and softened in advance to avoid equipment wear.
Prohibited operations:
Do not mix hard objects or metals into the medicine to prevent scratching the mold and damaging the gears;
Do not modify the motor or transmission structure privately;
In a humid environment, ensure grounding for electrical safety.
|
|
|
0938-2721678 
